The Zone Controllers offer
extended utility to the DriveRack®and ZonePro families. The nine
Zone Controllers use analog DC voltage to provide logic control ranging
from zone source selection, volume and muting, to program or scene selection
and fire safety muting. Wired with readily available and affordable
CAT5 cable with universally accepted rj-45 connectors at distances up
to 1000 ft, the ZC Zone Controllers offer simple yet elegant solutions
to the contractor.
The ZC-1 provides programmable remote volume control for the DriveRack
260, 220i and the ZonePro 640 and 641. The ZC-2 offers programmable
volume and mute control for the DriveRack 220i, 260 and the ZonePro
640 and 641. The ZC-3 can function as a program selector for the DriveRack
260 and 220i; in addition it can be used for as a source selector, page
steering control, or a scene selector for the ZonePro products. The
ZC-4 provides program change capability from contact closures for the
DriveRack 220i and 260; it can also provide source selection, page steering,
or scene selection for the ZonePro 640 and 641. The ZC-6 is a programmable
volume control for the ZonePro 640 and 641. The ZC-7 is a programmable
push -to-talk page assignment controller for the ZonePro devices. The
ZC-8 provides both programmable source selection and volume control
to the ZonePro 640 and 641. The ZC-BOB allows “home run”
or parallel wiring to the DriveRack and ZonePro devices. The ZC-FIRE
is a dedicated fire safety interface for the ZonePro products that allows
selection of either system mute or scene selection upon being triggered
by either a relay or control voltage from the fire safety system.
All information is subject to change without notice.
|
|
• Programmable
Volume Control
• Program or Scene Selection
• Programmable Contact Closure Interface
• Up to 1000 ft. on CAT 5 Cable
• Programmable Push-To-Talk Paging
• Programmable Source Selection
|